Actions

MatrixMix

From MakerVan Labs

Revision as of 07:09, 1 December 2020 by Severin (talk | contribs) (update BOM, more details on version 0.1)
     
MatrixMix 4x4

Release status: beta [box doku]

Matrixmix01.jpg
Description A simple yet extendable matrix mixer
Last Version  0.1 (2017-12-11)
Download  GitHub Repo

A simple passive 4x4 matrix mixer. Extendable, and with sync passthrough.

Features

  • 4 Inputs
  • 4 Outputs
  • Extension ports so extend the mixer to many more inputs, or add buffers/amplifiers to the outputs
  • Sync passthrough, to support sync signals on the audio jack, like in Teenage Engineering Pocket Operator synths. Selectable on each input/output

Note: This is a passive mixer. So when you change one knob, there might be changes of loudness for the other channels as well. There’s no buffering between the channels, so it’s completely normal like that.

Pictures

Parts

Part of Circuit Part Number Distributor Amount Notes
Potentiometer (20kΩ lin) Bourns PTV09A-4225F-B203 DigiKey 16 Suggested for v0.1
Potentiometer (10kΩ log) Bourns PTV09A-4025S-A103 mouser 16 Alternative for reverse mounting
3.5mm jacks EBSF 35 reichelt
DigiKey
8
Resistors 1k/10k (?) reichelt 16

You can populate P1-P8 with 3-pin 2.54mm headers, and mix the two channels of a stereo plug together, or pipe the second channel through to other devices, in a mode compatible with the Pocket Operator synths or similar modules.

Connectors P9 and P10 can be used to connect multiple MatrixMix 4x4 boards together to create a matrix mixer with 8, 12 or even more inputs.


Versions

v0.1

This is an early prototype version of the MatrixMix 4x4 PCB. As such, it has one fun error in it: All potentiometers are backwards. So you have to turn each knob counterclockwise to make things louder. It’s a little unusual, but also kind of fun. Note though, that normally you would use logarithmic pots for audio signal. When soldering the PCB as is, this does not make much sense. So use linear pots instead (There are reverse logarithmic pots, but they are hard to come by).

One alternative is to flip the board upside down and solder the pots from the back side. That works quite well, just your inputs are now on the bottom (or your outputs on the left, depending on your flip). Make sure to solder the 3.5mm jacks in as originally intended, otherwise the sync-passthrough does not work anymore.

  • Potentiometers are wired the wrong way, they all turn the wrong way
  • 10k Pots and 10k mixing resistors don't turn things all the way down

References